ADA4000-1ARZ Analog Devices Inc, ADA4000-1ARZ Datasheet - Page 5

• Manufacturer Part Number: ADA4000-1ARZ
• Description: IC OPAMP JFET 5MHZ PREC LP 8SOIC
• Manufacturer: Analog Devices Inc

Specifications of ADA4000-1ARZ

• Slew Rate: 20 V/µs
• Design Resources: Power off protected data acquisition signal chain using ADG4612 , AD711, and AD7476 (CN0165)
• Amplifier Type: J-FET
• Number Of Circuits: 1
• Gain Bandwidth Product: 5MHz
• Current - Input Bias: 5pA
• Voltage - Input Offset: 200µV
• Current - Supply: 1.35mA
• Current - Output / Channel: 28mA
• Voltage - Supply, Single/dual (±): 8 V ~ 36 V, ±4 V ~ 18 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Op Amp Type: Low Power
• No. Of Amplifiers: 1
• Bandwidth: 5MHz
• Supply Voltage Range: ± 4V To ± 18V
• Amplifier Case Style: SOIC
• No. Of Pins: 8
• Operating Temperature Range: -40°C To
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Output Type: -
• -3db Bandwidth: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

ABSOLUTE MAXIMUM RATINGS
Table 3.
Parameter
Supply Voltage
Input Voltage
Differential Input Voltage
Output Short-Circuit Duration to GND
Storage Temperature Range
Operating Temperature Range
Junction Temperature Range
Lead Temperature (Soldering, 10 sec)
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
Rating
±18 V
±V supply
±V supply
Indefinite
−65°C to +150°C
−40°C to +125°C
−65°C to +150°C
300°C
Rev. A | Page 5 of 16
THERMAL RESISTANCE
θ
soldered in a circuit board for surface-mount packages.
Table 4. Thermal Resistance
Package Type
5-Lead TSOT (UJ-5)
8-Lead SOIC (R-8)
8-Lead MSOP (RM-8)
14-Lead SOIC (R-14)
14-Lead TSSOP (RU-14)
POWER SEQUENCING
The op amp supply voltages must be established simultaneously
with, or before, any input signals are applied. If this is not
possible, the input current must be limited to 10 mA.
ESD CAUTION
JA
is specified for the worst-case conditions, that is, a device
ADA4000-1/ADA4000-2/ADA4000-4
θ
172.92
112.38
141.9
88.2
114
JA
θ
61.76
61.6
43.7
56.3
23.3
JC
Unit
°C/W
°C/W
°C/W
°C/W
°C/W