MC68030FE25C Freescale Semiconductor, MC68030FE25C Datasheet - Page 157

• Manufacturer Part Number: MC68030FE25C
• Description: IC MPU 32BIT ENHANCED 132-CQFP
• Manufacturer: Freescale Semiconductor

Specifications of MC68030FE25C

• Processor Type: M680x0 32-Bit
• Speed: 25MHz
• Voltage: 5V
• Mounting Type: Surface Mount
• Package / Case: 132-CQFP
• Family Name: M68000
• Device Core: ColdFire
• Device Core Size: 32b
• Frequency (max): 25MHz
• Instruction Set Architecture: RISC
• Supply Voltage 1 (typ): 5V
• Operating Supply Voltage (max): 5.25V
• Operating Supply Voltage (min): 4.75V
• Operating Temp Range: 0C to 70C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 132
• Package Type: CQUAD
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Lead Free Status / Rohs Status: Compliant

6.2 CACHE RESET
6.3 CACHE C O N TR O L
6.3.1 Cache Control Register
6-20
the cache control register (CACR) for both caches (refer to Figure 6-14) are
The CACR, shown in Figure 6-14, is a 32-bit register that can be written or
during the second, third, or fourth cycle of a burst operation does not cause
When a hardware reset of the processor occurs, all valid bits of both caches
are cleared. The cache enable bits, burst enable bits, and the freeze bits in
also cleared, effectively disabling both caches. The WA bit in the CACR is
also cleared.
Only the MC68030 cache control circuitry can directly access the cache arrays,
cache operations. The supervisor also has access to the cache address reg-
cache. Each cache is controlled independently of the other, although a similar
operation can be performed for both caches by a single MOVEC instruction.
On the initial access of a burst operation, a "retry" (indicated by the assertion
of BERR and HAL-I = ) causes the processor to retry the bus cycle and assert
CBREQ again. However, signaling a retry with simultaneous BERR and HALT
a retry operation, even if the requested operand is misaligned. Assertion of
BERR and HALT during burst fill cycles of a burst operation causes inde-
pendent bus error and halt operations. The processor remains halted until
HALT is negated, and then handles the bus error as described in the previous
paragraphs.
but the supervisor program can set bits in the CACR to exercise control over
ister (CAAR), which contains the address for a cache entry to be cleared.
read by the MOVEC instruction or indirectly modified by a reset. Five of the
bits (4-0) control the instruction cache; six other bits (13-8) control the data
For example, loading a long word in which bits 3 and 1 1 a r e set into the
CACR clears both caches. Bits 31-14 and 7-5 are reserved for Motorola
definition. They are currently read as zeros and are ignored when written.
For future compatibility, writes should not set these bits.
MC68030 USER'S MANUAL
MOTOROLA